Truck Cleaner 2000 is a basic, highly concentrated cleaning agent with multifunctional action. It is intended for washing trucks. It can be used in washing high pressure devices, foaming systems and for manual washing.
The product removes strong dirt, insects etc without any problems.
During foam cleaning, it gives a rich and stable foam.
Application 1) Sprayers: for very dirty vehicles and as insect remover: dilution 1 to 10. Spray from bottom upwards. Let soak for about 60 seconds and spray off with high pressure. For less dirty vehicles a dilution of 1 to 25/50 liters will do. Apply in the same manner. 2) with foam unit: the use and dosage strongly depends on the used system but Nerta Drizzle Protect will fit any foam unit. 3) High Pressure Cleaner: dilution 1 to 10. Adjust the dosage tap till results are satisfying, about 0.5% to 2% at the sprayer head and an ideal temperature of 50°c . 4) Manual Cleaning: normally 1% dilution, 1 litre to 100 litres waters. Wash vehicle with sponge or brush, after finishing rinse again with plain water.
Features & Benefits:
Easy to use
Application of use
Foam Truck Cleaning
Applied as foam, (at a 3%-5% dosage through the Nerta injector and foam lance) it is very economical in use due to its outstanding coverage and dwell time. Typically a truck can be cleaned using less than 1 litre of TC 2000. This fast and easy to use, brush-less, truck cleaner gives an excellent clean with much less physical effort required than with standard traffic film removers, so is ideal for use on larger fleets, high cube trailers or by commercial cleaners. Any standard pressure washer can be fitted with a Nerta foaming system.
Standard Pressure Washer Application
The chemical dosage rates of pressure washers vary considerably and they rarely deliver as low a dosage as Nerta systems. TC 2000 is highly concentrated so, for maximum economy and cleaning performance, you need to dilute TC 2000 to match your equipment. Testing small batches, start at 1 part TC2000 to 9 parts water and gradually increase up to 1 part TC 2000 to 3 parts water. Choose the lowest dilution that cleans well at a mid range chemical setting on your pressure washer. TC 2000 will work well with cold water but does work better with hot water up to 40 degrees.
TC 2000 can also be applied using a pump sprayer at a 4% dilution. This method works well for washing small fleets or with less powerful pressure washers. TC 2000 can also be used for MOT and chassis cleaning if applied in this way at higher concentrations and with heat. NERTA TC 2000 is a strong alkaline and highly concentrated wash agent. It can be used as both a prewash and a wash in automated system with brushes, fogging systems and spray arches or highly diluted for manual use through high pressure cleaners and with foam systems. TC 2000 being used to wash a high cube trailer and tractor units: